Pot Magnet Ø48 mm with Internal Thread
 
The pot magnet is a magnet assembly containing a permanent magnet in a steel housing. The housing forms a magnetic circuit and directs flux from the poles towards the contact surface. In direct contact, holding force is typically much greater than that of a bare neodymium magnet. The housing and protective coating of a pot magnet can be selected to suit its application. This version uses a neodymium (NdFeB) insert for high holding force. Nickel-coated for improved surface protection and appearance. The internal thread allows quick mounting to a holder using a screw or threaded rod, with easy relocation when needed. Nominal diameter: Ø48 mm. Nominal pull-off force under ideal conditions: 60 kg (600 N).
 
The pot magnet performs best on solid steel with a minimal air gap. Allow a safety margin for sideways loads and carry out a trial installation. Useful wherever a quick, reusable attachment point is needed on steel, including holders, accessories and temporary assemblies. The pot partly protects the insert, but impacts can still damage it. Use moderate tightening force during installation and a washer where necessary. Standard NdFeB magnets can typically be used up to approximately 80°C. High temperatures can permanently reduce magnetism. Check the technical table for the exact limit.
 
Warning: keep away from children. Strong magnetic attraction can pinch fingers. Magnets can snap together suddenly and break. Store them with spacers and keep them away from bank cards, sensitive electronics and medical devices such as pacemakers.